S/Pdif Connector; Battery - DFI KD631-C236 User Manual

S/PDIF Connector

SPDIF out
Ground
S/PDIF
SPDIF in
+5V
1 5
The S/PDIF connector is used to connect an external S/PDIF port. Your S/PDIF port may be
mounted on a card-edge bracket. Install the card-edge bracket to an available slot at the rear
of the system chassis then connect the audio cable to the S/PDIF connector. Make sure pin 1
of the audio cable is aligned with pin 1 of the S/PDIF connector.
Chapter 2 Hardware Installation
Chapter 2

Battery

19
9
9
The lithium ion battery powers the real-time clock and CMOS memory. It is an auxiliary source
of power when the main power is shut off.
Safety Measures
• Danger of explosion if battery incorrectly replaced.
• Replace only with the same or equivalent type recommended by the manufacturer.
• Dispose of used batteries according to local ordinance
28
19
Battery
9 9
.
www.dfi .com