CHIEF PL-4 Installation Instructions

I N S T A L L A T I O N
RPA SERIES PROJECTOR LOCK
The PL-4 Projector Lock is designed to provide security
for your LCD/DLP Projector when it is attached to the
RPA series ceiling mount.
INSTALLATION
1. Two methods of installation are possible:
a. Run steel cable through projector handle and
then through RPA series ceiling mount.
b. Before attaching adhesive plate, clean area on
projector with alcohol wipe. Attach the adhesive
retainer plate to exterior chassis of the projector.
NOTE: Adhesive will secure retainer in plate to
projector and become fixed. For maximum
adhesive strength, adhere retainer plate to
projector and do not attempt to remove the
cable lock right away. Allow the adhesive to
become stronger and cure over time.
2. Securely lock cable to cylinder lock.
3. Retain keys.
Lock
Assembly
Clip Retainer with
Adhesive Backing.
Adhere to Projector.
Chief Manufacturing, a division of Milestone AV Technologies
8401 Eagle Creek Parkway
Savage, MN 55378 USA
P: 800.582.6480 / 952.894.6280 F: 877.894.6918 / 952.894.6918
I N S T R U C T I O N S
(PL-4)

PARTS LIST

Unpack the shipping carton and check for the contents
listed in Table 1.
REF
10 ADHESIVE RETAINER PLATE
20 CABLE LOCK ASSEMBLY
30 KEYS
40 ALCOHOL WIPE
SLB- Hanging
RPA
Bracket
Projector
Table 1. Parts List
DESCRIPTION
8803-000039 Rev. C
©2008 Milestone AV Technologies
www.chiefmfg.com
QTY
1
1
2
1
10/08