Table of Contents
Advertisement
This Manual Is Designed to Make it as Easy as Possible for You to Assemble,
Install, Operate and Maintain Your Ceiling Fan
Tools Needed for Assembly
One Phillips head screwdriver
One 1/4" blade screwdriver
MATERIALS
Wiring outlet box and box connectors must be of
type required by the local code. The minimum wire
would be a 3-conductor (2-wire with ground) of the
following size:
WARNING
!
Do not install or use fan if any part is damaged or
missing. Call Toll-Free:
1-800-654-3545
WARNING
!
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product by
Emerson Electric Co. Substitution of parts or
accessories not designated for use with this product
by Emerson Electric Co. could result in personal
injury or property damage.
1. Check to see that you have received the following
parts:
NOTE: If you are uncertain of part description,
refer to exploded view illustration.
a. Fan motor assembly
b. One coupling cover
c. One ceiling cover
d. Five fan blades
e. Five fan blades support plates
f. One lower housing
g. One light kit assembly including: one bowl cap and
one finial nut
h. One hanger bracket
i. One hanger ball/4.5" downrod assembly
j. One lower glass
k. Three 25-watt (maximum) candelabra base bulbs
l. One loose parts bag containing:
1. One clevis pin
2. One hairpin clip
3. Three 12 ga. wire connectors
4. Two #8-32 x 1-1/4" threaded studs
5. Two #8 external tooth lockwashers
6. Two #8-32 knurled knobs
7. Sixteen #10 - 24 x 15mm washer head screws
8. One #8 - 32 x 10mm pan head screw
9. Two pull chain couplings
One stepladder
One wire stripper
Unpacking Instructions
Installed Wire Length
Up to 50 ft.
50-100 ft.
!
Before assembly your ceiling fan, refer to section
on proper method of wiring your fan (page 8).
If you feel you do not have enough wiring
knowledge or experience, have your fan installed
by a licensed electrician.
10. Two wood pendants (large & small)
11. One balancing kit
NOTE: Place the parts from the loose parts bags
in a small container to keep them from being lost.
If any parts are missing, contact your local
retailer or catalog outlet for replacement before
proceeding.
2. Remove and discard the two cardboard shipping
retainers securing the motor hub in the motor
housing assembly.
3. Remove the fan motor assembly from the
protective plastic bag. Place all carton contents on
a protective surface.
H. HANGER
BRACKET
J. LOWER
GLASS
3
Wire Size A.W.G.
14
12
WARNING
A. FAN MOTOR
B. COUPLING
ASSEMBLY
COVER
C. CEILING
COVER
D. FAN
BLADES
G. LIGHT KIT
F. LOWER
ASSEMBLY
HOUSING
I. HANGER BALL/
4.5" DOWNROD
ASSEMBLY
L. LOOSE
K. 25-WATT
PARTS BAG
CANDELABRA
BASE BULBS
U.L. Model No.: CF850
E. BLADE
SUPPORT
PLATES
Advertisement
Table of Contents
