Tuning Into Stations; Auto Browse Station - Tecsun PL-680 Operation Manual

TECSUN RADIOS AUSTRALIA

TUNING INTO STATIONS

Press the [POWER] button to turn on your radio, then select your
desired band by pressing [FM], [AM], SW [
In case of receiving FM/AIR/SW broadcasting, fully extend the
telescopic antenna for a better reception. When receiving MW and
LW broadcasting, please rotate the radio or change its location to
achieve optimum reception. You can rotate the [VOLUME] knob to
adjust to an appropriate volume.
Now, you can turn into your favorite stations with any of the below
tuning methods:
METHOD 1: MANUAL STATION TUNING
Press the [VF/VM] button to enter the
frequency mode (VF), the frequency
display flashes twice. Now rotate the
[TUNING] knob to select your desired
station.
METHOD 2: AUTO BROWSE STATION
1. Press the [VF/VM] button to enter the
frequency mode (VF), the frequency
display flashes twice.
2. Press & hold the [VF/VM] button to
browse to the next available station,
pre-listening the station for five
seconds before continuing to browse.
3. To stop the auto browse function,
simply rotate the [TUNING] knob or
press on the [VF / VM] button again
to confirm on your desired station.
Notes:
1. While operating the "Auto Browse Station" function, you can press
the [MEMORY] button anytime to store the station into memory,
and the radio will keep on auto browsing the next available
station.
2. The "Auto Browse Station" function is not available for Air Band
and SW SSB frequencies.
6
www.tecsunradios.com.au
] / [ ], or [AIR] button.
flashing
SL EEP
0 1 2 3 4 5
Ni-MH
Battery
MHz
FM
Frequency mode
Searching
Frequency
flashing
SL EEP
0 1 2 3 4 5
Ni-MH
FAST
Battery
MHz
FM

Auto browse station

PL-680