Burner And Tumbler / Lint Chamber Manual Reset Hi-Limit Instructions; Gas Models Only - ADC AD-30 Installation Manual

Hide thumbs Also See for AD-30:

Table of Contents

BURNER AND TUMBLER / LINT CHAMBER

MANUAL RESET HI-LIMIT INSTRUCTIONS

FOR MECHANICAL METER, TIMER OR PHASE 5 WITHOUT HEAT FAULT

This dryer was manufactured with a burner manual reset hi-limit and tumbler/lint chamber hi-limit thermostat.

If either burner manual reset hi-limit thermostat is open prior to the start of the drying cycle, or during the cycle,

the dryer will not recognize the open state of the burner hi-limit thermostat and will start or continue through the

drying cycle with no heat. Manual reset hi-limit thermostat must be reset manually.

This hi-temperature condition may be caused due to a restricted exhaust, poor airflow, or improper burner

oven operation.

The location of the manual reset hi-limit switch is on the right side of the burner box.

SECTION XI

IMPORTANT

IMPORTANT

This dryer is equipped with a burner

hi-limit and tumbler/lint chamber hi-limit

thermostat which must be reset manually.

WARNING: Discontinue power to dryer

before attempting to reset hi-limit.

American Dryer Corp.

ADC P/N:114093

113063 - 11

Table of Contents

Ml-30