Table of Contents
Advertisement
Using the auto-adjustment function (analog input)
The auto-adjustment feature automatically engages and attempts to optimize your screen under the following
conditions:
•
Monitor setup
•
Factory reset of the computer
•
Changing monitor resolution
You can manually optimize the screen performance for the VGA (analog) input at any time from the Auto
Adjustment menu in the OSD. You can download the auto-adjustment pattern software utility from
http://www.hp.com/support.
Do not use this procedure if the monitor is using an input other than VGA. If the monitor is using a VGA (analog)
input, this procedure can correct the following image quality conditions:
•
Fuzzy or unclear focus
•
Ghosting, streaking, or shadowing effects
•
Faint vertical bars
•
Thin, horizontal scrolling lines
•
An off-center picture
To use the auto-adjustment feature:
1. Turn the monitor on, and then wait for for 20 minutes before adjusting.
2. Press the
Menu
is not satisfactory, continue with the procedure.
3. Open the auto-adjustment utility. (You can download this utility from http://www.hp.com/support.) The
setup test pattern is displayed.
4. Press the
Esc
button to open the OSD menu, select Image, and then select Auto-Adjustment. If the result
key or any other key on the keyboard to exit the test pattern.
3 Support and troubleshooting
19
Advertisement
Table of Contents
