Setting Up The Monitor; Installing The Stand (Select Models) - HP LD4200 User Manual

3

Setting Up the Monitor

To set up the monitor, ensure that the power is turned off to the monitor, computer system, and other
attached devices, then follow the instructions below.

Installing the Stand (Select Models)

1. Remove the six M4 x 12mm screws (1), monitor stand (2) and cable management clip (3) from the
box.
Figure 3-1
2. Place a soft cloth on the table and place the product with the screen facing downward. Connect
the stand as shown in the following illustration.
Figure 3-2
4 Chapter 3 Setting Up the Monitor
Stand Accessory Contents
Sliding the Stand Onto the Monitor
ENWW