Connecting Daisy Chain Monitors; Vesa Mounting Support - HP LD4200 User Manual

Press the INPUT button on the remote control to select the input signal. Press the SET button to
save your change.
Or, press the SOURCE button on the back side of the monitor panel. Press the AUTO/SET button
to save your change.
a. When connecting with a VGA signal input cable, select the RGB PC from the Input menu.
b. When connecting with a HDMI to DVI signal input cable, select HDMI/DVI from the Input menu.
NOTE: If connecting two monitors, connect the signal cables (HDMI to DVI and VGA) to each
computer. Press the INPUT button on the remote control to select the computer use.
CAUTION:
for a prolonged period of time (12 consecutive hours of non-use). To avoid burn-in image damage on
the monitor screen, you should always activate a screen saver application or turn off the monitor when
it is not in use for a prolonged period of time or cycle between 5 minutes of static information and 10
seconds of a moving image. Image retention is a condition that may occur on all LCD screens. Screen
burn-in is not covered under the HP warranty.

Connecting Daisy Chain Monitors

Use this function when displaying analog RGB inputs of a computer to the other product.
To use different products connected to each other, connect one end of the signal input cable (15-pin D-
Sub VGA signal cable) to the RGB Out connector of product 1 and connect the other end of the RGB
In connector of other products.
Figure 3-18

VESA Mounting Support

This product supports a VESA FDMI compliant mounting interface. On the rear of the monitor are four
VESA mounting holes that allow you to install a mounting device to the monitor. The mounting devices
are purchased separately and not available from HP. Refer to the instructions included with the mount
for additional information.
ENWW
Burn-in damage may occur on monitors that display the same static image on the screen
Connecting Several Monitors to the Computer
Connecting to External Devices 13