Walker H38i Operator's Manual page 16

Safety Instructions - Operating
14. The maximum recommended slope operat-
ing angle is 15 degrees or 26% grade. When
operating the machine on a slope, reduce speed
and use caution to start, stop, and maneuver.
To prevent tipping or loss of control of the ma­
chine, avoid sharp turns or sudden changes in
direction. Do not operate the machine on a
slope greater than 15 degrees.
15. Never adjust cutting height with the engine
running. Before adjusting cutting height or
servicing, disengage the blade clutch (PTO),
stop the engine, and remove the ignition key.
Wait for all movement to stop before getting off
the seat.
NOTE: The blade/PTO brake should normally
stop drive line rotation within five (5) seconds of
dis engaging the PTO clutch.
16. For side discharge mower decks, do not oper-
ate with the grass deflector shield removed.
Keep the deflector in the low est possible posi­
tion.
17. When using the tilt­up deck, observe the fol-
lowing:
a. Do not move tractor with deck in tilt­up
position.
b. Never tilt body forward with deck in tilt­up
position.
18. In case of a clogged or plugged mower deck:
a. Disengage the blade clutch (PTO), engage
the parking brake, and turn the engine off
before leaving the seat.
b. LOOK to make sure blade drive shaft
move ment has stopped before trying to un­
clog the system.
c. Disconnect the spark plug wires.
d. Never place hands under the deck ­ use a
stick or similar tool to remove clogged ma­
terial.
12
19. If the cutting blades strike a solid object or the
machine begins
immediately disengage the blade clutch
(PTO), stop the engine, and wait for all
moving parts to stop. To prevent accidental
starting, disconnect the spark plug wires.
Thoroughly inspect the mower and repair any
damage before restarting the engine and
operating the mower. Make sure cutter blades
are in good condition and blade nuts are torq­
·
ued to 60 lb ft (81 N
and blade bolts torqued to 70 lb
belt driven decks.
20. Do not touch the engine or muffler while the
engine is running or immediately after stop­
ping the engine. These areas may be hot
enough to cause serious burns.
21. When leaving the machine unattended, disen-
gage the blade clutch (PTO), stop the en-
gine, and remove the key.
to vibrate abnormally,
·
m) for gear driven decks,
· ·
ft (95 N m) for