Walker H38i Operator's Manual page 54

Maintenance Instructions
Ident
No. Location
1 Deck Caster Wheel Fork Pivot
2 Deck Caster Wheel Bearing
3 Front Deck Lift Pivot
4 Rear Deck Lift Pivot
5 Pivot Assembly, Tilt-Up Deck
6 Deck Support Arm Socket
7 Steering Lever Pivot
8 Deck-to-PTO Coupling
(Grease Spline Slide Area)
9 Deck Support Arm Pivot
10 Universal Joint Tube Assembly
11 FSC Lever Pivot
12 Hydro Idler Arm Pivot
13 Body Latch Pivot
14 PTO Clutch Lever Pivot
15 Clutch Arm Pivot
16 Transaxle Oil Reservoir
17 Throttle Control Cable Ends
18 Engine Dipstick
50
Lubrication No.
Type Places
Grease 2
Grease 2
Grease 2
Grease 2
Δ
Grease 2
Grease 2
Grease 2
Grease 1
Grease 2
*
Grease 1
Grease 1
Grease 1
Oil 2
Grease 1
Grease 1
Oil 1
Oil 2
**
Oil 1
Ident
No. Location
19 Tail Wheel Caster Fork Pivot
20 Rear Axle Pivot
21 Rear Wheel Bearing
22 Engine / Oil Filler
23 PTO Belt Tightener Pivot
24 Clutch Actuator Push Rod
25 Brake Band Pivot Pins (Clevis)
26 Parking Brake Pivot
27 Parking Brake Clevis
28 Throttle Control Pivot
29 Universal Joint Shaft Assembly
Δ
30 Blade Spindle
*
Grease every twenty-five (25) hours.
**
Refer to Engine Oil located on page 46.
Fitting located underside, access with deck in tilt-up posi-
Δ
tion.
NOTE: DR64 Tilt-Up Deck is shown for reference. For other
Deck Lubrication Points, refer to Deck and Carri-
er Frame Illustrated Parts Manual.
LUBRICATION
Lubrication No.
Type Places
Grease 2
Grease 1
Grease 2
**
Oil 1
Grease 1
Grease 1
Oil 2
Grease 1
Oil 3
Oil 1
*
Grease 1
Grease 3