Fuel Tank Selector Valve; Adjustable Foot Rests; Adjusting Cutting Height - Walker H38i Operator's Manual

Operating Instructions
In case the transmission drive belt breaks
during operation, and if the machine is on
a slope, the machine will freewheel down
the slope. To maintain control, immedi-
ately (1) Release the steering levers and
simultaneously (2) Move the FSC to the
NEUTRAL-PARK position.
machine is stopped or moving slowly,
engage the parking brake.
NOTE: The emergency stop procedure is ex­
actly the same procedure as used to normally
stop and park the machine.

FUEL TANK SELECTOR VALVE

The tractor is equipped with dual fuel tanks. A fuel
selector valve regulates which tank is being utilized.
The valve is located on the left hand side of the en­
gine. The valve switches between the LH and RH
gas tanks. DO NOT run tank dry before switching
tanks.
Fuel Tank
Selector Valve
Fuel Tank Selector Valve
40
WARNING
When the

ADJUSTABLE FOOT RESTS

Some carrier frames are outfitted with adjustable
foot rests. To adjust, rotate the footrests upward and
slide to the desired position. Rotate the footrest
down and insert the edge of the footrest into the
nearest notch to lock in position.
Adjustable Footrest

ADJUSTING CUTTING HEIGHT

WARNING
Never adjust cutting height while the
mower is moving.
cutting height or servicing, move the
Forward Speed Control (FSC) into the
NEUTRAL-PARK position, engage the
parking brake, and disengage the blade
clutch (PTO). Tractor should not be
moving while adjusting cutting height.
Cutting height is adjusted from operator's seat using
the deck lift pedal to assist in raising the deck while
adjusting the cutting height hitch pin.
1. Disengage PTO and stop tractor.
2. Push down on deck lift pedal until it latches in
the full up (transport) position.
3. Select the desired cutting height by moving the
hitch pin to the location shown on the cutting
height decal.
4. Push down on the lift pedal and lift up on the
cutting height release lever. Slowly release the
pedal while lifting the lever until the deck is in
the selected cutting height position.
Before adjusting