Table of Contents
Advertisement
Assembly Instructions
Battery Charging
BATTERIES PRODUCE EXPLOSIVE GASES
Charge the battery in a well-ventilated
●
area, so that gases produced while
charg ing can dissipate.
●
Keep sparks, flames, and smoking ma-
terials away from the battery at all
times.
●
Make sure the battery charger is un-
plugged before connecting or discon-
necting cables to the battery.
1.
Disconnect the battery terminals–negative (-)
first.
2.
Charge the battery at 15 amps for 10 minutes.
DO NOT exceed 20 amps maximum recom-
mended charging rate. Total charging time
should not exceed one (1) hour.
3.
Reconnect the battery terminals starting with
the positive (+) terminal.
Battery Installation
IMPORTANT: Make sure battery is securely
mounted in the frame. A loose battery may cause
damage to the case resulting in acid leakage and
severe damage to the machine. A hazard may be
created by damage to critical working parts and
safety systems.
Install the battery in the mower as shown in Bat-
tery Installation photo. Connect the positive (+)
first and then the negative (-) cable to the proper
battery terminal [red cable and boot connects to
the Positive (+) terminal]. Slide the rubber boot
up and over the battery post, making sure it covers
the post completely to prevent an electrical
short.
20
DANGER
Battery Clamp Secured
(+) Battery Cable
Connection
Battery Installation
(Viewed from RH Side)
Mower Deck Assembly
CAUTION
The engine must be off during the tractor
assembly and deck installation.
Deck Caster Wheels Installation
1.
Remove the bolts and washers from each
deck caster wheel.
2.
Install wheel on fork using bolts and washers.
3.
Tighten the bolts and washers.
4.
Grease caster wheel bearings and caster
wheel pivot bearings (one fitting for each pivot).
Deck Caster Wheel Installation
H24d
by Wing Nut(s)
Advertisement
Table of Contents
