Attaching A Ferrite Core - Panasonic KX-TDA150 Installation Manual
Hybrid ip-pbx
Hide thumbs
Also See for KX-TDA150:
- Programming manual (68 pages) ,
- User manual (238 pages) ,
- Getting started (32 pages)
Table of Contents
Advertisement
2.2.8 Attaching a Ferrite Core
A ferrite core must be attached when:
•
an RJ45 connector is connected to T1, E1, PRI, BRI, IP-GW16, IP-EXT16, or DMPR cards.
•
an Amphenol connector is connected to an extension card.
•
an RJ11 connector is connected to the DMPR card.
Attaching to an RJ45 Connector
For T1/E1/PRI/IP-GW16/IP-EXT16 Cards
Wrap the cable once around the ferrite core, then close the case of the ferrite core. Attach the ferrite core 5 cm
away from the connector. The ferrite core is included with the card.
For the DMPR Card
Wrap the cable once around the ferrite core, then close the case of the ferrite core. Attach the ferrite core 3 cm
away from the connector. The ferrite core is included with the PBX.
5 cm
3 cm
2.2.8 Attaching a Ferrite Core
Installation Manual
49
Advertisement
Table of Contents
Troubleshooting
