Attaching A Ferrite Core - Panasonic KX-TDA600 Installation Manual

2.2.15 Attaching a Ferrite Core

2.2.15 Attaching a Ferrite Core
A ferrite core must be attached when:
•
an RJ45 connector is connected to T1, E1, PRI, BRI, IP-GW16 or IP-EXT16 cards, or
•
an Amphenol connector is connected to an extension card.
The ferrite core is included with the card.
Note
In Canada, the ferrite core is not necessarily required for the T1 and PRI23 cards.
Attaching to an RJ45 Connector
For T1/E1/PRI/IP-GW16/IP-EXT16 Cards
Wrap the cable once around the ferrite core, then close the case of the ferrite core. Attach the ferrite core 5
cm away from the connector. The ferrite core is included with the card.
118 Installation Manual
5 cm