Table of Contents
Advertisement
CHANGING THE SAW BLADE
DISCONNECT THE SAW FROM
THE MAINS SUPPLY!
IT IS ADVISABLE TO WEAR GLOVES
WHEN REMOVING THE BLADE!
1. Put the table back to the level position if it has been tilted.
Set the upper blade guide assembly approximately midway
in the throat. Open the top and bottom doors and remove the
table insert.
2. Release the blade tension by turning the tensioning knob
counter-clockwise and remove the table stabilising bolt, see fig
69-70.
Fig 69-70
3. Remove the saw dust deflector, and place safely aside see fig
71. The blade can be easily slipped off the wheels. Remove the
blade carefully, 'wiggling' it clear of the upper blade guard and
through the lower blade guard and out the slot in the table, see
fig 72-73-74-75.
Fig 71-72-73-74-75
Table stabilising bolt
4. This would be an
excellent time to clean out
the interior of the machine;
remove the impacted 'crud'
from the tyres, apply a little
light oil to the screw threads
of the blade and drive belt
tensioners and the track-
ing control. The pivots and
the slides of the top wheel
mounting assembly and
the captive stub axle of the
drive belt tensioner in its
slot could likewise be lightly
oiled.
5. If you are fitting a new blade, it will have been supplied to
you "folded" , bound together in this configuration with tape
or tie wrap.
28
Advertisement
Table of Contents
