Axminster Professional AP1854B Original Instructions Manual page 25

ELECTRO-MAGNETIC MOTOR BRAKE SWITCH/EXTRACTION OUTLETS
The electro-magnetic brake switch is located below the
NVR switch asssembly and has two positions.
• Position (1) engages the motor brake to prevent the bandsaw
blade from moving and to isolate the bandsaw to prevent it
from being started accidentally, see fig A.
• Position (2) is for running the machine. Move the selector
switch to this position, the 'Green LED' light should glow on
the NVR switch control panel, (AP1854BV Only). Press the
'Green' button on the NVR switch to start the bandsaw,
see fig B-C.
SAFETY NOTE! IF THE MAINS SUPPLY IS CUT
THE MAGNETIC BRAKE IS ENGAGED STOPPING
THE BANDSAW INSTANLY.
SAFETY NOTE! TURNING THE SWITCH TO
POSITION '1' WILL ENGAGE THE MAGNETIC
BRAKE STOPPING THE BANDSAW INSTANLY.
Fig A-B
Position 1 isolates the bandsaw and
engages the motor brake
Fig C
Control Switch (AP1854BV)
Position 2 puts power to the bandsaw
and releases the motor brake
Control Switch (AP1854B)
Dust Extraction Outlets
The bandsaw comes with three extraction outlets for
extracting the various materials to be cut. See the table
below for the correct connections for the various materials.
To avoid cross contamination clean thoroughly when changing
material type.
Port Wood Only
A
B
C
C
25
Extraction Outlets
Metal Plastic
If mounted
to the stand
If bench
mounted
AP1854BV ONLY
B
If mounted
to the stand
If bench
mounted
A