Table of Contents
Advertisement
ROUTING MAINTENANCE
DISCONNECT THE SAW FROM
THE MAINS SUPPLY!
Daily
• Keep the machine clean.
• Check the saw blade for missing teeth and cracks, see fig 82
• Spray oil the bare metal surfaces.
• If you are constantly using the bandsaw during the day, open
up the wheel doors and clean out all the compacted saw dust.
IMPORTANT NOTE: If you are cutting metal, clean the lower
blade guides and lower wheel daily!
Weekly
• Open the top and bottom wheel covers and clean out all the
saw dust with in.
Clean out impacted 'crud' and saw dust
Clean out impacted 'crud' and saw dust
C
Fig 80
• Check the condition of the tyres (A)
• Check for missing teeth (B)
• Check the condition of the drive belt (C)
Monthly
• Open the lower and upper door and check the
condition of the tyres and the drive belt, see figs 81-82-83.
• Clean impacted 'crud' from the tyres, apply a little oil to the
screw threads of the blade and drive belt tensioners. DO NOT
USE OIL near the belt.
• The pivots and the slides of the top wheel mounting
assembly and the captive stub axle of the belt tensioner in its
slot could likewise be lightly oiled.
• Using an air line (wearing goggles) blow out the motor
casing.
30
Fig 81-82-83
B
A
Advertisement
Table of Contents
