SPECIFIC OPERATING INSTRUCTIONS
Fig 56-57
H
Standard table insert for cutting wood
I
Table insert for cutting plastic/metal (AP1854BV ONLY)
PLEASE NOTE AS THERE IS ZERO CLEARANCE ON THE TABLE INSERT (I),
YOU WILL BE UNABLE TO MAKE ANY CUTS WHEN THE TABLE IS TILTED!
Fig 59-60
Fence Micro Adjuster
The fence assembly can be adjusted in small increments. To do
this first tighten the micro adjuster clamp (A), release the fence
clamping handle (B) then turn the micro adjuster knob (C) to
make positive or negetive changes to the fence, see 58-59-60.
Lock
Fig 58
C
B
A
24