Unfolding The Stroller; Installing The Front Wheels - Joovy 455 Instruction Manual

Unfolding the Stroller

• Keep children away from stroller while unfolding.
• Position the stroller with the handle bar closest to you.
• Release the locking latch located on the right side by lifting the lever off of the
extended rivet. See Figure 2.
• Lift up slightly on the handle of the stroller. Then place one foot onto the rear
platform and pull up and back on the handle until both side frame bars snap into
their locking positions in the frame.
• Lock the safety latch on the lower left side of the stroller by pushing the lever
down over the extended rivet. See Figure 3.
• Ensure that the stroller is completely opened and the safety latch is secured
before ANY use of the stroller.
Figure 2
ALWAYS secure the safety latch on the side of the stroller when it is in the
unfolded use position. This will prevent collapse of the stroller should the
handle trigger locks be accidentally opened.

Installing the Front Wheels

• Take one of the double wheel sets and
locate the small hole in the rotating
bracket that is inside the red lever.
• Push the front axle into this hole and keep
pushing the wheel set onto this axle until
you hear an audible click. See Figure 4.
• Pull downward on the wheel set to
ensure that it has locked into position on
the axle.
• Repeat this same procedure for the other
wheel set.
• When assembled properly, both wheel
sets should rotate and roll smoothly.
Page 
Figure 3
WARNING
!
Figure 
Caboose Ultralight Instruction Manual