Pre-Alarm - Honeywell Notifier ID60 Series Operating Manual
Hide thumbs
Also See for Notifier ID60 Series:
Table of Contents
Advertisement
ZONE FIRE
1
2 3 4
ZONE FAULT
DISABLE/TEST
FIRE
POWER SUPPLY FAULT
DISABLEMENT
TEST
SOUNDER: FAULT/ DISABLED
FIRE CONTROL O/P: FAULT/ DISABLED
997-264-000-10, Issue 10
January 2010
ID50 Series Panel - Operating Manual
3.2 Pre-alarm
When one or more input devices signal to the panel a
reading higher than normal but not yet at the FIRE level,
this is a PRE-ALARM condition.
Automatic panel actions
a. Intermittent operation of the internal buzzer (one
b. Operation of the appropriate ZONE FAULT/DISABLE/
FAULT
EARTH FAULT
c. Displays information on the LCD regarding the pre-
SYSTEM FAULT
PRE-ALARM
Status: FAULT
PRE-ALARM
d. Operation of any assigned outputs in response to a
Recommended operator actions:
1 Operate the MUTE buzzer pushbutton to silence the
2 Check condition of sensor indicated and check area
8
second ON, one second OFF).
TEST LED and yellow PRE-ALARM LED.
alarm condition.
01/02
general pre-alarm condition at the panel (refer to
Section 5.7 Control-by-Event Rules).
panel's internal buzzer.
for possible fire. If the cause cannot be determined
notify authorised servicing company.
14:55
Advertisement
Table of Contents
