Honeywell Notifier ID60 Series Operating Manual page 27

or
2 8 5
5
[U0 Zones]
2:No Sounders
[U0 Zones]
2
ID50 Series Panel - Operating Manual
i
[STOP WALK TEST] Select Zone: 01
Press
ii Press the '
The system has no walk test zones active
iii Press the '
b. For all zones: from the ' : More' option ('
1: Ring Sounders
3:View/Stop Test
4: Stop All
Stop all Zones in Walk Test ?
4
Press
4 To exit the Test Zones menu, press the '
Checking the Devices
Use the following methods to check devices during a walk test:
i. Test sensors by applying smoke or heat as
ii. Test Manual Call Points by using a test key.
For each device, the panel will record the event in the
log, sound its internal buzzer, illuminate the appropriate
ZONE FIRE LED and, if a CLIP protocol device, turn on
the LED at the device that initiated the alarm.
For OPAL protocol devices the longer green LED flash
duration is replaced, after testing, by the normal poll flash.
Note: A maximum of ten devices' LEDs can be illuminated
23
Use the ' / ' buttons to select the zone, then press
2 8
the ' ' button to confirm the zone number.
5
to Confirm
' button to stop the walk test for the
5
selected zone. If no other walk tests are active, the
following is displayed:
' button to exit the Walk Test menu and
4
return to the Test Zones menu.
press the ' ' button on the numeric keypad to select
4
the Stop All menu:
8
: More
: More
to Confirm
Continue pressing this button until the required menu
or the 'Status: NORMAL' message is displayed.
appropriate, or by operating the device's internal test
switch by means of a magnet.
during the test. Further device testing functions
normally in all other respects. LEDs will not light
again until after the removal of the walk test
condition and manually resetting the panel.
<:Cancel
<:Exit
/ ')
2 8
<:Cancel
' button.
4
997-264-000-10, Issue 10
January 2010