Replacing The Hard Disk Drive; To Replace The Hard Disk Drive - HP OmniBook 500 Startup Manual

Replacing the Hard Disk Drive

Important

To replace the hard disk drive

You'll need a small Phillips screwdriver for this procedure.
1. Unplug the AC adapter, if present, and remove the battery.
2. Turn the unit bottom side up and remove the hard drive retaining screw.
3. Carefully pull the hard drive out of the computer.
4. Gently slide the new drive into the hard drive compartment. Press firmly to make sure
the connector seats properly.
5. Reinstall the hard drive retaining screw.
If you are installing a new hard disk drive, you should create a Utility partition on the
drive before loading any software. See "To recover the factory installation of your hard
disk" on page 61.
To install the holder on a new hard disk drive or prepare a new hard disk for use, see
"Replacing the Hard Disk Drive" in the online Reference Guide.
Add-On Devices
Replacing the Hard Disk Drive
Startup Guide 51