Replacing A Hard Disk Drive - HP OmniBook XE2-DE - Notebook PC Setup Manual

Replacing a hard disk drive

Note
Configuring and Expanding Your Computer
Replacing a hard disk drive
You'll need a small Phillips screwdriver to complete this procedure.
1. From the Start menu, shut down the computer.
2. Unplug the AC adapter, if present, and remove the battery.
3. Turn the unit bottom side up.
4. Use a screwdriver to remove the hard disk drive locking screw.
5. Slide and hold the hard disk drive latch.
6. Slide the hard disk drive toward the edge of the computer, then lift out.
7. Insert the new hard disk drive and the locking screw.
8. Insert the battery.
If you are installing a new hard disk drive, you should create a Hibernate partition on
the drive before loading any software. See "Expanding the Hibernate Partition" on page
47.
46 Setup Guide