HP OmniBook 500 Startup Manual page 50

Note
Add-On Devices
Installing Additional RAM
4. Carefully insert the edge of the RAM module into the connector at about a 30° angle
until it is fully seated. Then press down on both sides until the latches snap closed.
5. Replace the cover.
6. Insert the battery.
Windows 98 only: if you increase your computer's memory to more than 512 MB, the
computer will not be able to hibernate unless you also increase the size of the Utility
partition on the hard disk—see "To recover the factory installation of your hard disk" on
page 61.
To remove the RAM module, release the two latches at the sides of the module.
You can also replace the system RAM module beneath the keyboard—see "Installing
Additional RAM" in the online Reference Guide.
50 Startup Guide