Installation; Operation; Lock/Unlock The Doors - Polar Electro CE322-A Instruction Manual

AU

Installation

Note: If the unit has not been
stored or moved in an upright
position, let it stand upright for
approximately 12 hours before
operation. If in doubt allow to
stand.
1. Remove the appliance from the packaging.
Make sure that all protective plastic film and
coatings are thoroughly removed from all
surfaces.
2. Maintain a distance of 20cm (7 inches)
between the unit and walls or other objects for
ventilation. NEVER LOCATE NEXT TO OR
NEAR A HEAT SOURCE.
Note: Before using the appliance
for the first time, clean the
shelves and interior with soapy
water.
Reverse the Door
1. Disconnect the appliance from the power
supply.
2. Tip the appliance back slightly to gain access
to the lower hinge.
3. Unscrew the lower hinge and pivot pin.
Remove from the door.
4. Carefully lower the door and remove it from
the appliance.
5. Unscrew the upper pivot pin located
underneath the protective covers from the
appliance and slot the reversed pin in to the
opposite side. Secure with the two screws.
6. Slot the door back on to the upper pivot pin.
7. Slot the lower hinge and pivot pin back in to
the bottom of the door.
8. Screw the lower hinge back on the appliance
with the two screws.
Note: The fixings must use the
holes on the other side of the
hinge when switching sides
[Fig. 1].
4
CE322-A_A5_v7_20181127.indb 4
Telephone Helpline: 1300225960
1

Operation

Thermostat
The thermostat is located at the rear of the cabinet
[Fig. 2].
2
Turn On
1. Set the temperature to the desired setting:
1 (8°C) to 6 (2°C).
Note: Setting the switch to '0'
turns off the appliance.
2. Close the door of the appliance.
3. Connect the appliance to a mains power
supply.

Lock/Unlock the Doors

• A lock is fitted to the doors of this POLAR
appliance.
• Use the keys provided to lock/unlock the door.
2018/11/27 10:28