Front Wheel - Yamaha XJR1300X Owner's Manual

Front wheel

To remove the front wheel
WARNING
G It is advisable to have a Yamaha
dealer service the wheel.
G
Securely support the motor-
cycle so that there is no danger
of it falling over.
1. Place the motorcycle on the cen-
terstand.
2. Loosen the front wheel axle pinch
bolt, then the wheel axle and the
brake caliper bolts.
1. Wheel axle
2. Front wheel axle pinch bolt
PERIODIC MAINTENANCE AND MINOR REPAIR
EAU24360 3. Remove the brake hose holder
and reflector on each side by re-
moving the bolt.
EAU33681
4. Remove the brake caliper on each
side by removing the bolts.
EWA10820
1. Brake caliper bolt
2. Brake hose holder
3. Reflector
4. Bolt
5. Brake caliper
CAUTION:
Do not apply the brake after the
brake calipers have been removed,
otherwise the brake pads will be
forced shut.
5. Pull the wheel axle out, and then
remove the wheel.
To install the front wheel
1. Lift the wheel up between the fork
2. Insert the wheel axle.
3. Install the brake calipers by install-
NOTE:
Make sure that there is enough space
between the brake pads before install-
ing the brake calipers onto the brake
discs.
4. Install the brake hose holders and
5. Take the motorcycle off the center-
6. Tighten the wheel axle, the front
ECA11050
6-32
legs.
ing the bolts.
reflectors by installing the bolts.
stand so that the front wheel is on
the ground.
wheel axle pinch bolt and the
brake caliper bolts to the specified
torques.
Tightening torques:
Wheel axle:
72 Nm (7.2 m·kgf, 52 ft·lbf)
Front wheel axle pinch bolt:
20 Nm (2.0 m·kgf, 14 ft·lbf)
Brake caliper bolt:
40 Nm (4.0 m·kgf, 29 ft·lbf)
EAU33770
6