Operation And Important Riding Points; Starting The Engine - Yamaha XJR1300X Owner's Manual

OPERATION AND IMPORTANT RIDING POINTS

WARNING
G Become thoroughly
with all operating controls and
their functions before riding.
Consult a Yamaha dealer re-
garding any control or function
that you do not thoroughly un-
derstand.
G
Never start the engine or oper-
ate it in a closed area for any
5
length of time. Exhaust fumes
are poisonous, and inhaling
them can cause loss of con-
sciousness and death within a
short time. Always make sure
that there is adequate ventila-
tion.
G
Before starting out, make sure
that the sidestand is up. If the
sidestand is not raised com-
pletely, it could contact the
ground and distract the opera-
tor, resulting in a possible loss
of control.
EAU15950
EWA10270
NOTE:
This model is equipped with a lean an-
familiar
gle sensor to stop the engine in case of
a turnover. To start the engine after a
turnover, be sure to turn the main
switch to "OFF" and then to "ON". Fail-
ing to do so will prevent the engine from
starting even though the engine will
crank when pushing the start switch.
EAU45310

Starting the engine

In order for the ignition circuit cut-off
system to enable starting, one of the
following conditions must be met:
G
G
G
G
1. Turn the key to "ON" and make
CAUTION:
The following warning lights and in-
dicator light should come on for a
few seconds, then go off.
G
G
5-1
The transmission is in the neutral
position.
The transmission is in gear with
the clutch lever pulled and the sid-
estand up.
WARNING
Before starting the
check the function of the igni-
tion circuit cut-off system ac-
cording to the procedure
described on page 3-21.
Never ride with the sidestand
down.
sure that the engine stop switch is
set to " ".
Oil level warning light
Engine trouble warning light
EAU33724
EWA10290
engine,
ECA12741