GAS GAS EC250-F SUOMI User Manual page 45

. During the oil filter change, check the o-rings and change it if you
find a problem (crack)
1
5. Replace the filter cover and put the screws that secure the cover,
but without tightening them too hard (do not exceed the recommended
torque).
6. Put the oil cap on the carter and lock it. By the flywheel carter
hole, introduce 1.300 ml of oil. (H)
WARNING
The engine may be damaged if the oil is not used properly or the
specifications recommended by GAS GAS MOTOS are not followed.
Use the type of oil specified in the section on Petrol and Oil
recommendations.
(H)
1
1
45
-
7. Unlock the pression control screw 1
- Start the engine and stay at the idle to check if the oil is coming
by this pression control screw.
After 1 min, if the oil is not coming, stop the engine.
-Check if the oil tub or the oil pump are not block and check the
etancheity.-
-After the solving problem, check again the oil pressure.
- Lock the pression control screw at 10 Nm.
8 .Remove the oil level screw K, the oil must exit by this hole when
the bike is straight.
(K)
11. If more oil is needed it can be topped up through the opening
in the ignition cover (H).
-
1