Black & Decker MT280 Original Instructions Manual page 9

Assembly
Fitting and removing the accessories
(fig. A - F)
Warning! Before fitting an accessory,
disconnect the tool from the mains supply.
Fitting a BLACK+DECKER / Piranha
accessory (fig. A - C)
• Hold the tool and squeeze the accessory
clamping lever (3).
• Slide the accessory (8) between the
shaft and the accessory holder making
sure the accessory engages all eight pins
on the holder and is flush with the shaft.
• Release the accessory clamping lever.
Note: Some accessories, such as scrapers
and blades can be mounted at an angle if
required (fig. C).
Removing a BLACK+DECKER / Piranha
accessory accessory (fig. A)
Carbide grout removal
blade.
(Part number -
X26125-XJ)
Carbide coated surface
ideal for clearing grout
and tile adhesive from
flat surfaces and for fast
stock removal of wood,
chipboard and
fibreglass.
Carbide rasp.
(Part number -
X26130-XJ)
Carbide coated surface
ideal for grout removal
and for fast stock
removal of plastics,
chipboard and
fibreglass.
Sanding Sheets.
Various grades for
sanding of wood,
painted and varnished
surfaces.
(Original instructions)
• Hold the tool and squeeze the accessory
clamping lever (3).
• Pull the accessory from the tool making
sure the accessory dis-engages from all
eight pins on the holder.
• Release the accessory clamping lever.
Warning: Gloves must be worn when
removing accessories as then may become
hot during use.
Fitting a sanding sheet (fig. D)
• Line up the sanding sheet (9) with the
sanding base (4) as shown.
• Press the sheet firmly and evenly onto the
sanding base, making sure that the holes
in the sheet coincide with the holes in the
base.
Removing a sanding sheet
• Pull the sanding sheet off the sanding
base (4).
Warning! Never use the sanding base
without a sanding sheet or accessory in
place.
Fitting the dust extraction adaptor (fig. E)
• Line up the dust extraction adaptor (5)
with the sanding base (4) as shown.
• Press the adaptor firmly and evenly in to
the sanding base.
• Secure the adaptor by turning the locking
nut (12) clockwise.
• Connect a vacuum cleaner to the dust
extraction adaptor.
Removing the dust extraction adaptor
• Turn the locking nut (12) anti-clockwise.
• Pull the dust extraction adaptor (5) out of
the sanding base (4).
Fitting alternative accessories (fig. F)
• Place the spacer (6) onto the collar (10).
• Place the alternative accessory (11) onto
the collar (10).
ENGLISH
9