Using The Appliance - Fagor FF-8012 Installation And Operation Manual

Table of Contents

Advertisement

Available languages

Available languages

WASH PROGRAMME PHASES
7
AND POWER CUTS
On display models, when the programme is
running, the phase the programme is at will
appear on the display together with the time
remaining before the programme ends. On
non-display models the phase the programme
is at is shown by the LEDs.
The active phases will appear successively at
the top of the display as the programme
progresses. The time remaining until the end
of the programme will also appear on the
display. It updates at regular intervals, but not
minute by minute.
Any option button can be selected provided
the wash phase in which it takes effect has
not been passed and when the programme
accepts the option.
Pressing the delay button during the wash has
no effect on the washing machine.
Pressing the start/pause button during the
wash activates the PAUSE function.
If you change the wash programme
during the wash using the selector,
the PAUSE function is activated and
the programme is cancelled.
If you need to add or remove a
garment, press the start/pause button
and make sure that the water level is
not above the door overflow level and
that the temperature inside is not high.
Press the start/pause button again to
restart the wash from the same cycle
phase it had stopped at.
If there is a power cut, when the electricity
comes back on the washing machine will
continue to run from where it left off (it has
several hours of memory). The same will
happen if the ON/OFF button is pressed.
PROGRAMME
PHASES
POWER CUTS

using the appliance

1100
700
400
Level the washing machine by adjusting the
feet to reduce the noise caused by spin-drying.
Try and wash clothes of different sizes in
the same wash programme to favour the
distribution of the clothes inside the drum
during spin-drying.
All the models have a safety system for
spin-drying that prevents spin-drying from
being carried out if the distribution of the
clothes inside the drum is too concentrated.
This prevents the appliance from vibrating too
much.
If you find that the clothes are not properly
wrung out, try spin-drying them again after
having distributed the clothes more evenly in
the drum.
85
3h
6h
9h
warnings

Advertisement

Table of Contents
loading

Table of Contents