Installing Optional Idsdm Or Vflash Card; Removing The Microsd Card - Dell E60S Installation And Service Manual

Installing optional IDSDM or vFlash card

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the air shroud.
Steps
1. Locate the IDSDM/vFlash connector on the system board. To locate IDSDM/vFlash connector, see
and connectors section.
2. Align the IDSDM/vFlash card with the connector on the system board.
3. Push the IDSDM/vFlash card until it is firmly seated on the system board.
Figure 62. Installing optional IDSDM or vFlash card
Next steps
1. Install the MicroSD cards.
NOTE: Reinstall the MicroSD cards into the same slots that are based on the labels you had marked on the cards during
removal.
2. Install the air shroud.
3. Follow the procedure that is listed in

Removing the MicroSD card

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the air shroud.
4. Remove the IDSDM or vFlash module.
Steps
1. Locate the MicroSD card slot on the vFlash/IDSDM module, and press the card to partially release it from the slot. To locate
IDSDM/vFlash module, see the
2. Hold the MicroSD card and remove it from the slot.
Safety instructions.
Before working inside your
After working inside your
Safety instructions.
Before working inside your
System board jumpers and connectors
system.
system.
system.
section.
Installing and removing system components
System board jumpers
65