Table of Contents
Advertisement
NOTE:
It is recommended that you always use an antistatic mat and antistatic strap while working on components inside
the system.
Before working inside your system
Prerequisites
Follow the safety guidelines listed in
Steps
1. Power off the system and all attached peripherals.
2. Disconnect the system from the electrical outlet, and disconnect the peripherals.
3. Remove the system cover.
After working inside your system
Prerequisites
Follow the safety guidelines listed in
Steps
1.
Install the system
cover.
2. Place the system upright on a flat, stable surface.
3. Reconnect the peripherals and connect the system to the electrical outlet.
4. Power on the attached peripherals and then power on the system.
Recommended tools
You need the following tools to perform the removal and installation procedures:
● Key to the bezel lock
The key is required only if your system includes a bezel.
● Phillips #1 screwdriver
● Phillips #2 screwdriver
● 5mm hex nut screwdriver
● Plastic scribe
● Wrist grounding strap connected to the ground
● ESD mat
Front bezel
Removing the front bezel
Prerequisites
1. Follow the safety guidelines listed in
2. Keep the bezel key handy.
Steps
1. Unlock the bezel.
2. Press the blue release latch at the top of the bezel to release the bezel from the system.
20
Installing and removing system components
Safety
instructions.
Safety
instructions.
Safety
instructions.
Advertisement
Table of Contents
