Figure 37. Installing a 3.5-inch drive adapter into the 3.5-inch drive carrier
Next steps
1.
Replace a 3.5-inch drive carrier into the
2. Follow the procedure listed in
Optical drive and tape drives
Removing the optical or tape drive blank
Prerequisites
NOTE:
The procedure to remove the optical drive blank is identical to removing a tape drive blank.
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the front bezel.
Steps
1. Slide the release latch downwards to remove the drive blank.
2. Push the drive blank to slide it out of the drive bay.
system.
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Installing and removing system components
41