Electrical Connection - Miele G 6060 Operating Instructions Manual

Electrical connection

The appliance is supplied with a mains
cable with moulded plug ready for con-
nection to a switched socket.

The electrical socket must be
easily accessible after the dish-
washer has been installed. Do not
connect the dishwasher to the mains
electricity supply by an extension
lead. Extension leads do not guaran-
tee the required safety of the appli-
ance (e.g. danger of overheating).
If the connection cable is damaged, it
must be replaced with a Miele cable of
the same type (available from Miele) by
a Miele approved service technician or
suitably qualified person only.
Do not connect the appliance to an in-
verter such as those used with an
autonomous energy source e.g. solar
power. When switched on, peak loads
in the system can cause the safety
switch-off mechanism to be triggered.
This can damage the electronic unit.
The appliance must not be used with
so-called energy-saving devices
either. These reduce the amount of en-
ergy supplied to the appliance, causing
it to overheat.
82

Before connecting the appliance,
check that the connection data on
the data plate (voltage, frequency
and fuse rating) matches the mains
electricity supply. If in any doubt,
consult a qualified electrician.
The data plate is located on the right-
hand side of the door.

The electrical installation must
be in compliance with current local
and national safety regulations. In
the U.K. it must comply with BS
7671.