Problem solving guide
Water inlet fault
Problem
The In-operation indic-
ator is flashing quickly.
The buzzer is sounding.
The Inlet/Drain indic-
ator is flashing on and
off.
The In-operation indic-
ator is flashing quickly.
The buzzer is sounding.
The Inlet/Drain indic-
ator is flashing and fault
code or has ap-
peared in the display.
70
Cause and remedy
The stopcock is closed.
Open the stopcock fully.
Before rectifying the problem:
Switch the dishwasher off with the button.
The water intake is restricted.
Open the stopcock fully and start the programme
again.
Clean the water inlet filter (see "Maintenance").
The water pressure at the intake is lower than 50
kPa (0.5 bar).
Seek professional advice.