Setting The Rinse Aid Dosage - Miele G 6060 Operating Instructions Manual

Setting the rinse aid dosage

You can adjust the rinse aid dosage for
best results.
The rinse aid dosage can be set in
steps from 0 to 6. The factory default
setting is 3. This is the recommended
setting.
The rinse aid dosage can turn out to be
higher than the set value due to the
automatic adjustment of the pro-
gramme.
If spots appear on crockery and glass-
ware:
 Increase the rinse aid dosage.
If clouding or smearing appears on
crockery and glassware:
 Decrease the rinse aid dosage.
Before using for the first time
 Switch the dishwasher off with the 
button, if it is switched on.
 Press the programme selector but-
ton  in and, whilst holding it in,
switch the dishwasher on using the
 button.
Keep the programme selector but-
ton  pressed in for at least four
seconds until the bottom right indic-
ator light comes on.
If this does not happen, start the pro-
cedure from the beginning again.
 Press the Short button three times.
The Short indicator will flash rapidly 3
times at intervals.
The dosage set will appear in the dis-
play after .
  will start flashing in the display.
Setting 3 is set (factory default).
 Use the programme selector but-
ton  to select the required setting.
The dosage amount increases each
time you press the button.
The setting is now stored in memory.
 Switch the dishwasher off with the
 button.
27