Viking E-1600A-TP2-EWP Technical Practice page 8

G. Voice Announcer/Miscellaneous Options
The 1600A series phones have a built-in non-volatile digital voice announcer that may be used to identify the location
of the emergency phone call. The 16 seconds of digital record time is recorded remotely from a Touch Tone phone.
Programming options are as follows:
Factory Default Setting: 0 + 0 + 1 + 2 + 1 + 0
Two Digit Announcement Delay {
Repeat Announcement Setting
Hang-up on Return to Dial Tone
Double Ring Cadence Mode
Lap Counter
Settings A and B - Announcement Delay
The 1600A series phone is factory set to automatically start playing the
voice announcement after it has determined the call has been answered.
Alternately, the announcement may be programmed to play after a pro-
grammed amount of time, from 1 to 99 seconds after dialing.
* Note: If the announcement delay time is used, you must allow enough time for the 1600A series phone to detect
ring-no-answer and busy signals when using the redial features. The factory default is set to play automatically.
Setting C - Repeat Announcement Option
The 1600A can be programmed to play the announcement from 1-9 times,
or to continuously repeat the announcement every 8 seconds until a
Q
Touch Tone is detected from the distant party. The call connected LED
will turn on automatically after the announcement has stopped repeating.
* Note: The factory default for the 1600A series phone is to play the voice announcement once (digit 1).
Setting D - Hang Up on Return to Dial Tone
If enabled and a return dial tone is detected, the 1600A will hang up.
* Note: The factory default setting is enabled.
Setting E - Double Ring Cadence Mode
The 1600A series phone can be programmed to recognize the double ring cadence
that is typical of many phone systems. If the 1600A series phone is connected to
an extension that provides a double ring cadence, enabling this mode will allow for
proper call progress detection.
* Note: This feature is disabled in the factory default setting.
Setting F - Lap Counter
With the lap counter disabled (factory setting), if the 1600A series
phone is programmed to dial the next number on ring-no-answer and/or
busy signal (see page 6-7), the 1600A series phone will continuously
call its programmed phone numbers forever until the call is answered.
The lap counter is a programmable counter that determines how many times the 1600A series phone will cycle
through its list of up to 5 emergency number (or up to 3 "Info" phone numbers), before it stops the dialing process
and hangs up. When all of the programmed phone numbers have been dialed, the lap counter is incremented and
the dialing process repeats. When the lap counter has been met, the dialing process stops and the 1600A series
phone hangs up. * Note: This feature is disabled in the factory default setting.
8
(memory location #17)
Dial: A + B + C + D + E + F + # + 1 + 7
Enter Settings Here:
A B C D E
Touch Tone Setting A/B
00 Play automatically
01-99 1-99 seconds*
Touch Tone Setting C
0 Repeat every 8 secs
1-9 Repeat 1-9 times*
Touch Tone
1
2
Touch Tone
1
2
Touch Tone Setting F
0 Disabled*
1-9 Lap count = 1-9 times
F
#17
Setting D
Disabled
Enabled*
Setting E
Disabled*
Enabled