Vcr Setup; Cable Tv Setup - Hyundai HLT-3010 Owner's Manual

VCR Setup

- In Video mode, TV automatically reverts to TV mode if the fcr button
Connection 1
Connection 2
1. Connect the audio/video output jacks on VCR to the corresponding
2. Insert a video tape into the VCR and press PLAY on the VCR. (Refer
3. Use the INPUT SELECT button on the remote control to select AV1

Cable TV Setup

- After subscribing to a local cable TV service and installing a converter,
you can watch cable TV programming.
- For further cable TV information, contact a local cable service provider.
Connection 1
1. Select 3 or 4 with channel switch on cable box.
2. Tune the TV channel to the same selected output channel of cable box.
3. Select channels at the cable box or with the cable box remote control.
Connection
1. Connect the audio/video output jacks on Cable Box to the corre-
2. Use the INPUT SELECT button on the remote control to select AV1
3. Select channels with the cable box remote control.
12
or flashbk buttons are pressed.
Set VCR switch to 3 or 4 and then tune TV to the same channel num-
ber.
input jacks on the TV. When connecting the TV to a VCR, match the
jack colors (Video = yellow, Audio Left = white, and Audio Right =
red).
to the VCR owner's manual.)
or AV2. (If connected to S-VIDEO on side panel, select the S-Video
external input source.)
2
sponding input jacks on the TV. When connecting the TV to Cable
Box, match the jack colors
(Video = yellow, Audio Left = white, and Audio Right = red).
or AV2.
VIDEO L AUDIO R VIDEO L R S-VIDEO
AUDIO
AV2 AV1
Typical
Antennas
ANT IN
S-VIDEO OUT
ANT OUT
VCR
IN
CH3 CH4
Direct
(R) AUDIO (L) VIDEO
Connection
VIDEO VIDEO L L AUDIO AUDIO R R S-VIDEO S-VIDEO
VIDEO VIDEO L L AUDIO AUDIO R R ANT. IN ANT . IN
A A V2 V2
A A V1 V1
(R) AUDIO (L) VIDEO
TV
VCR
RF Cable
Cable Box
ANT. IN AC INPUT
AC INPUT AC INPUT