Federal Communications Commission Notice; Modifications; Cables - HP Compaq Presario,Presario 1700 Reference Manual

13-2
Government Approvals
The equipment is designed to work with all EU telephone networks. However, the
equipment may have interworking difficulties for some connections on the EU
public networks. Dialing by loop disconnect pulses is not intended to be used on
the PSTN. This feature is only supported in consideration of PBX or other
equipment that requires pulse dialing. Network compatibility is dependent on
software switch settings that are set automatically by the country selection. The
user should contact the equipment supplier in case of difficulty in network settings.

Federal Communications Commission Notice

This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception (which can be determined by
turning the equipment off and on), the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio or television technician for help.

Modifications

The FCC requires the user to be notified that any changes or modifications made to
this device that are not expressly approved by Compaq Computer Corporation may
void the user's authority to operate the equipment.

Cables

Connections to this device must be made with shielded cables with metallic
RFI/EMI connector hoods in order to maintain compliance with FCC Rules and
Regulations.