Federal Communications Commission Notice - HP 6720t - Mobile Thin Client Getting Started

466202-002.book Page 15 Wednesday, February 20, 2008 11:44 PM
Regulatory markings for your country may be located on the bottom of the product,
under the battery, under a user-removable door (or some other user-accessible
location), or on the wireless or modem module.

Federal Communications Commission notice

This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
■
Reorient or relocate the receiving antenna.
■
Increase the separation between the equipment and receiver.
■
Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected.
■
Consult the dealer or an experienced radio or television technician for help.
Modifications
The FCC requires the user to be notified that any changes or modifications made to
this device that are not expressly approved by HP may void the user's authority to
operate the equipment.
Cables
To maintain compliance with FCC Rules and Regulations, connections to this
device must be made with shielded cables having metallic RFI/EMI connector
hoods.
Declaration of Conformity for products marked with the
FCC logo (United States only)
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following 2 conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that
may cause undesired operation.
Getting Started
Product information
15