Entering Drivelock Passwords - HP Compaq NX9600 Hardware And Software Manual

3. Open the Setup utility by turning on or restarting the
notebook. Press
lower-left corner of the screen.
4. Use the arrow keys to select Security > DriveLock
Password, and then press
5. Read the warning, and then press
6. Type the new password in the Enter New Password field,
and then press
7. Type the new password in the Confirm New Password field,
and then press
8. To confirm DriveLock protection on the drive you have
selected, type
press
9. Press
10. To save your preferences and exit the Setup utility, press
and then follow the instructions on the screen.
Your preferences are in effect when the notebook restarts.

Entering DriveLock Passwords

Each time you restart the notebook, you are prompted to enter the
DriveLock password.
To enter the DriveLock password:
»
Type the DriveLock password in the Enter DriveLock
Password field, and then press
✎
After 3 incorrect attempts to enter the password, you must
restart the notebook and try again.
Hardware and Software Guide
while Setup message is displayed in the
f10
enter.
enter.
DriveLock
f10.
to continue.
enter
enter.
enter.
in the confirmation field, and then
enter.
Security
f10,
5–13