Accessing The Network At Startup - HP Compaq NX9600 Hardware And Software Manual
Compaq business notebook series
Hide thumbs
Also See for Compaq NX9600:
- Maintenance and service manual (198 pages) ,
- Hardware and software manual (251 pages) ,
- Hardware manual (104 pages)
Table of Contents
Advertisement
Communications
Accessing the Network at Startup
To connect the notebook to a PXE (Preboot eXecution
Environment) server during startup, you must enable the internal
NIC for startup, and then respond to the Network Service Boot
prompt each time you want to connect to the server.
■
To enable the NIC for startup and set the notebook to display
the Network Service Boot prompt each time the notebook is
started or restarted, set your preferences in the Setup utility.
For more information about using the Setup utility, refer to
"Using the Setup Utility,"
✎
■
To respond to the Network Service Boot prompt, press
while the prompt "F12 = Boot from LAN" is displayed very
briefly in the lower-left corner of the screen before
Windows loads.
8–4
The Setup utility is not a Windows utility and does not
support the TouchPad.
in
Chapter 9.
Hardware and Software Guide
f12
Advertisement
Table of Contents
