Enabling Devices In Computer Setup - HP Compaq NC6110 Software Manual

The list below describes the order in which drive numbers are
assigned. (The actual startup sequence varies by configuration.)
Sequence for devices that boot as drive A:
1. Optical drive in a Port Replicator MultiBay or in an external
MultiBay that contains a disc that boots as drive A.
2. Diskette drive in a Port Replicator MultiBay or in an
external MultiBay.
3. SuperDisk drive in a Port Replicator MultiBay or in an
external MultiBay.
Sequence for devices that boot as drive C:
1. Optical drive in a Port Replicator MultiBay or in an external
MultiBay that contains a disc that boots as drive C.
2. Hard drive in the notebook hard drive bay.
3. Hard drive in a Port Replicator MultiBay or in an external
MultiBay.
✎
Since no drive letter is associated with the NIC, changing the boot
order of a NIC does not affect drive letters of the other devices.

Enabling Devices in Computer Setup

The notebook can only start up from a USB device or the NIC if
that device has been enabled for inclusion in MultiBoot.
To enable a device or location for inclusion in MultiBoot:
1. To open Computer Setup, turn on or restart the notebook.
Press
displayed in the lower left of the screen.
❏
❏
Software Guide
while the F10 = ROM Based Setup message is
F10
To change the language, press
For navigation instructions, press
F2.
F1.
MultiBoot
5–3