Download Print this page
MULTISPAN EM-10 Operating Manual

MULTISPAN EM-10 Operating Manual

3 phase energymeter

Advertisement

Quick Links

OPERATING MANUAL
3 PHASE ENERGY METER
EM-10
. 
R Y B
kWh
CT PRIMARY SELECTION:
1) Press
Key & power on unit to display  (CT ratio mode) on immediately
CT
releasing key, unit allows to edit CT ratio up to 4000/5.
2) CT ratio change by using
decrease CT ratio press
power on the instrument.
RESETTING kWh.
1) Press
Key for 10 second than display show   than press
RESET
KWH
then display show  than wait kwh is reset.
EM-10
Technical Specification
Size (mm)
EM 10
Panel Cutout
Voltage Input
Current Input
Active Power
Active Power
Power Supply
RESET
CT
KWH
KW
Frequency
(As per request)
Operating
Temperature
Humidity
&
CT
RESET
KWH
to save changes power off the unit, and normally
RESET
KWH
Page - 1
Model
Display
6 Digit/Line 7 seg 0.56 ,red LED Display
96(H) X 96 (W) X 50 (D) mm
5 Amp or higher through external CT
(KW)
(KWh)
230V AC,50 Hz, Approx 4VA
Wiring
System
Protection
IP-65 (Front side) As per IS/IEC 60529 : 2001
Level
Relative
Up to 95% RH Non Condensing
key press
key to increase CT ratio and
CT
EM-10
92 X 92 mm
250V AC
0000-9999 KW
0-999999 KWH
45 To 65 Hz
3Ph-4W
0°C To 50°C
RESET
KWH
www.multispanindia.com
key

Advertisement

loading
Need help?

Need help?

Do you have a question about the EM-10 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for MULTISPAN EM-10

  • Page 1 OPERATING MANUAL 3 PHASE ENERGY METER EM-10 Technical Specification Model EM-10 Display 6 Digit/Line 7 seg 0.56 ,red LED Display 96(H) X 96 (W) X 50 (D) mm Size (mm) EM 10 Panel Cutout 92 X 92 mm Voltage Input 250V AC .
  • Page 2 System : 3 Ph-4W Current: 0.1 To 5A AC Accuracy Class: 1.0 Voltage(P-P) : 50-500V AC (P-N) : 30-300V AC CT Selection up to 4000/5 Amp AC CAT III 230V AC 50Hz, 4VA S2 S1 EM-10 Page - 2 www.multispanindia.com...
  • Page 3 1) The equipment should be cleaned regularly to avoid blockage of ventilating parts. 2) Clean the equipment with a clean soft cloth. Do not use isopropyl alcohol or any other cleaning agent. 3) Fusible resistor must not be replaced by operator. Page -3 www.multispanindia.com EM-10...
  • Page 4 Note: Product improvement and upgrade is a constant procedure. So for more updated operating information and Support, Please contact our helpline: 9978 9914 74 /76/ 82 or Email at service@multispanindia.com Ver: 11-2017 EM-10 Page - 4 www.multispanindia.com...