Sim Connector Board - HP Compaq 6530b Maintenance And Service Manual

6. Remove the rear cover (2) by lifting it straight up.
Reverse this procedure to install the rear cover.

SIM connector board

NOTE: This section applies only to computer models equipped with a WWAN module.
Description
SIM connector board
Before removing the SIM connector board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC Adapter from the computer.
4. Remove the battery (see
5. Remove the following:
a. Hard drive (see
b. Optical drive (see
c. Keyboard (see
d. Switch cover (see
e. Display assembly (see
f. Top cover (see
g. Rear cover (see
Battery on page 46).
Hard drive on page 52)
Optical drive on page
Keyboard on page 61)
Switch cover on page
Display assembly on page
Top cover on page 81)
Rear cover on page 93)
55)
65)
74)
Component replacement procedures
Spare part number
486252-001
95