Diagnostics Menu; System Configuration Menu - HP Compaq 6530b Maintenance And Service Manual

Select
TPM Embedded Security
(requires an administrator
password)
Disk Sanitizer
System IDs

Diagnostics menu

Select
System Diagnostics menu

System Configuration menu

NOTE: Some of the listed System Configuration options may not be supported by your computer.
Select
Language
Boot Options
106 Chapter 5 Computer Setup
To do this
●
Change TPM (Trusted Platform Module) Embedded Security device state at restart.
The following options are available:
◦ Do Nothing (enabled by default)
◦
Available and Disabled
◦ Available and Enabled
◦
Factory Defaults
● Reset Authentication Credential.
●
Enable/disable support for the following:
◦ Power-on authentication support (enabled by default)
◦
Operating system TPM management (enabled by default)
◦ Reset of TPM from operating system (disabled by default)
Run Disk Sanitizer to destroy all existing data on the primary hard drive.
CAUTION: If you run Disk Sanitizer, the data on the primary hard drive is destroyed
permanently.
Enter a user-defined computer asset tracking number and ownership tag.
To do this
●
F1 System Information—Displays the following information:
◦
Identification information for the computer and the batteries in the system.
◦
Specification information for the processor, cache and memory size, system
ROM, video revision, and keyboard controller version.
● F2 Start-up Test—Verifies the system components needed for starting the computer.
●
F3 Run-In Test—Runs a comprehensive check on system memory.
●
F4 Hard Disk Test—Runs a comprehensive self-test on any hard drive in the
system.
To do this
Change the Computer Setup language.
● Set a Startup Menu delay (in seconds).
●
Enable/disable Custom Logo (disabled by default).
● Enable/disable Display Diagnostic URL (disabled by default).