Bluetooth Module Cable - HP Compaq 6530b Maintenance And Service Manual

Remove the modem module cable:
1. Disconnect the modem module cable (1) from the system board.
2. Remove the modem module cable (2) from the clips built into the system board bracket.
3. Remove the RJ-11 connector (3) from the clip built into the base enclosure.
4. Remove the modem module cable.
Reverse this procedure to install the modem module cable.

Bluetooth module cable

NOTE: The Bluetooth module cable is included in the Cable Kit, spare part number 486281-001.
Before removing the Bluetooth module cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC Adapter from the computer.
4. Remove the battery (see
5. Remove the following:
a. Hard drive (see
b. Optical drive (see
c. Keyboard (see
d. Switch cover (see
e. Display assembly (see
Battery on page 46).
Hard drive on page 52)
Optical drive on page
Keyboard on page 61)
Switch cover on page
Display assembly on page
55)
65)
74)
Component replacement procedures 97