Audio Connector Board - HP Compaq 2710p Maintenance And Service Manual

Audio connector board

Description
Audio connector board (includes cable)
Before removing the audio connector board, follow these steps:
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
1.
computer on, and then shut it down through the operating system.
Disconnect all external devices connected to the computer.
2.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
3.
then unplugging the AC adapter from the computer.
Remove the battery (see
4.
Remove the following components:
5.
Hard drive compartment cover (see
a.
Keyboard (see
b.
Hinge cover (see
c.
Top cover (see
d.
Remove the audio connector board:
Release the ZIF connector (1) to which the audio connector board cable is connected and disconnect
1.
the audio connector board cable (2) from the system board. The audio connector board cable is
included with the audio connector board and is also available in the Cables Kit, spare part number
454682-001.
Remove the Phillips PM2.0×5.0 screw (3) that secures the audio connector board to the base
2.
enclosure.
Remove the audio connector board and cable (4).
3.
56 Chapter 4 Removal and replacement procedures
Battery on page 37).
Hard drive on page
Keyboard on page 48)
Hinge cover on page
Top cover on page 52)
39)
50)
Spare part number
454690-001