Fan/Heat Sink Assembly - HP Compaq 2710p Maintenance And Service Manual

Remove the system board (3) by sliding it away from the base enclosure at an angle.
8.
Reverse the preceding procedure to install the system board.

Fan/heat sink assembly

Description
Fan/heat sink assembly (includes replacement thermal material)
Before removing the fan/heat sink assembly, follow these steps:
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
1.
computer on, and then shut it down through the operating system.
Disconnect all external devices connected to the computer.
2.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
3.
then unplugging the AC adapter from the computer.
Remove the battery (see
4.
Remove the following components:
5.
Hard drive compartment cover (see
a.
Keyboard (see
b.
Hinge cover (see
c.
Top cover (see
d.
Display assembly (see
e.
System board (see
f.
Battery on page 37).
Hard drive on page
Keyboard on page 48)
Hinge cover on page
Top cover on page 52)
Display assembly on page
System board on page
39)
50)
60)
63)
Component replacement procedures
Spare part number
454692-001
65