Emerson CARRERA GRANDE ECO CF788CK00 Owner's Manual page 13

Wall Control Installation
NOTE: Make all wiring connections using wire
connectors (supplied). Make sure that all
connections are tight, including ground, and that
no bare wire is visible at the wire connectors,
except for the ground wire.
1. Disconnect electrical power to the branch circuit at
the circuit breaker or fuse box before attempting to
install the ceiling fan wall control into the outlet box.
2. Remove faceplate and screws from existing wall
control. Pull control out from the wall box.
Determine the "hot" wire and the "load" wire and
disconnect these wires from control. Do not attempt
to disconnect any wires not already connected to
existing control.
3. Before installing wall control, place wall control in
"OFF" mode by pushing "ON/OFF" switch to the
"OFF" position.
4. Connect one black wire of wall control to the "hot"
wire. Securely connect wires with wire connectors
supplied (Figure 17).
5. Connect one black wire of wall switch to the "load"
(black) wire in wall box. Securely connect wires
with wire connector supplied.
6. Screw wall control into wall box using the supplied
screws. Leave wall control in "OFF" mode until fan
installation is completed.
WARNING
!
Check to see that all connections are tight and that
no bare wires are visible at the wire connectors.
3-WAY INSTALLATION
(One fan controlled by two different wall controls)
(See Figures 18 and 19.)
WARNING
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is
turned off at the main fuse or circuit breaker box
before wiring. All wiring must be in accordance with
National and Local codes and the ceiling fan must be
properly grounded as a precaution against possible
electrical shock.
1. Disconnect electrical power to the branch circuit at
the circuit breaker or fuse box before attempting to
install the ceiling fan wall control into the outlet
box.
WARNING
!
Do not connect any neutral (white) wire to this
control. Incorrect wiring will damage this control.
(continued)
SCREWS (2)
DECORATIVE
WALL PLATE
Figure 17
7. The wall control is supplied with a white, ivory, and
almond color switch covers. Choose the finish that
best suits your needs and snap the cover onto the
wall control (Figure 17).
8. Install decorator wall plate using the two screws
provided with wall plate. Leave wall control in
"OFF" mode until fan installation is completed
(Figure 17).
!
Do not connect any neutral (white) wire to this
control. Incorrect wiring will damage this control.
2. At all wall box locations remove faceplates and
screws from existing controls. Pull controls out
from wall boxes and determine which wall box
contains the "hot" lead and which wall box contains
the "load" wire. Also, identify traveler wires which
are common to both wall boxes. Disconnect wires
from existing controls only. Do not attempt to
disconnect any wires not already connected to
existing controls.
3. Before installing wall control, place wall control in
"OFF" mode by pushing "ON/OFF" switch to the
"OFF" position.
4. Install a wall control in the wall box containing the
"hot" wire first. Connect the black wire of the wall
control to the "hot" wire. Securely connect wires
with wire connectors supplied.
5. Connect one black wire of the wall control to both
remaining traveler wires in the wall box and secure
with wire connector supplied.
NOTE: Retrofit 3-way installations are likely to
include two traveler wires between the two wall
boxes. In new construction, only one traveler wire
Is required (See Figure 19).
13
WALL BOX
SWITCH
COVER
FAN/LIGHT
WALL CONTROL
WARNING
ETL Model No.: CF788